AVERATEC 31 Series, User Manual

Page: 60 / 64

Appendix B — Statements
Statements
Federal Communications Commission Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and the receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Shielded interconnect cables and shielded AC power cable must be employed with this equipment to
insure compliance with the pertinent RF emission limits governing this device. Changes or
modifications not expressly approved by the system's manufacturer could void the user's authority to
operate the equipment.
Declaration of Conformity
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
•
This device may not cause harmful interference
•
This device must accept any interference received, including interference that may cause
undesired operation.
© AVERATEC, Inc.
Shielded interconnect cables and shielded AC power cable must be employed with this equipment to
insure compliance with the pertinent RF emission limits governing this device. Changes or
modifications not expressly approved by the system's manufacturer could void the user's authority to
operate the equipment.
FCC RF Radiation Exposure Statement:
( Wireless LAN )
1. This Transmitter must not be co-located or operating in conjunction with any other antenna
or transmitter.
2. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment.
This device was tested for typical lap held operations with the device directly
contacted to the human body to the back side of the notebook computer. To maintain compliance
with FCC RF exposure compliance requirements, avoid direct contact to the transmitting antenna during
transmitting.