Page|30
www.avenview.com
To install the projector at a location as showed above with the image just a little over required
region at any point. Too large image will lose image resolution and brightness.
Minimum keystone effect will optimize the image quality with less geometry alignment.
The image height from the projector can be higher than required and user can draw down the
image height through geometry alignment. The adjusting range is up to 1200 pixels in the top
and bottom edges.
During the installation, Laser Level is a good tool to get
correct horizontal and vertical line and make sure each
projector can cover correct display
Please reset all projectors to factory default settings.
Set to ceiling mount if necessary.
Disable below items:
Auto keystone, auto aspect ratio, auto color compensation, auto source searching
Select a display mode with gamma 2.2 or standard display mode. After edge blending, if user
still sees some banding in overlap region, please select the best one from different display
modes.
If there is color deviation among projectors, please try to correct color difference through
projector color adjusting function to let all color as close as possible.
Enable multiple projector display mode in some projector model.
7.5.3
Installation the projector
7.6
Projector settings before edge blending
