4.4
COMMAND SETTINGS
4.3
EXTENSION MACRO
Click on the ‘Extension Macro’ tab to access 8 more software macro buttons. These buttons are
configured in the same way as the hardware buttons and can be activated by clicking on them in the
WebGUI.
The ‘Command Settings’ tab is used to create new commands or delete unused commands. Up to 128
different commands can be saved and recalled. Commands can be up to 128 characters long.
If longer commands are required, up to 32 commands between 128 and 512 characters can be saved
with an additional 96 commands of 128 characters or less. Commands should be entered as ASCII text
or as hexadecimal characters and will be transmitted over Telnet or Ethernet as they are displayed. All
System (LED) Commands must end with ’\x0d\x0a’ These are the hexadecimal codes for Carriage
Return and Line Feed respectively.
See section 3.3 for the proper format of System Commands. As you can see below, the command used
to change an LED follows the format of the Telnet commands. (Including Carriage Return and Line
Feed characters)
Rev.00 12/2017
www.avenview.com
15
