EN
10
11
3.3. Assembling
1) Unfold the inflatable spa over the
base protector.
(Optional)
2) Bring the pump unit to the inflatable
spa.
3) Connect the inflation hose to the
pump on the socket .
6) Inflate the inflatable spa for about
10 minutes. Ensure that the spa is
firmly inflated.
10) Put the filter cartridge in the
support then screw it onto the lower
suction inside the basin.
7) Remove the inflation hose and
screw the cap firmly in place.
11) Ensure that the drain caps are
properly closed before before filling
the spa
8) Connect the unit pump to the pool
using the 3 connectors to screw.
Ensure the icons on the pump and the
pool match up
9) Cartridge location as shown.
12) Smooth wrinkles out of the bottom
of the spa, then fill the spa to the level
indicated. Your spa is ready.
4) Insert the inflation hose into the
inflatable spa
5) Connect the pump unit then press
the button to inflate the spa.
The air flow valve prevents your spa
from over-inflating.
Warling : Do not leave spa unattended while filling with water.
Make sure the drain fitting is plugged securely and the cap is in place. Start filling the spa with water. After
about 1-inch of water is on the bottom, stop filling and smooth wrinkles out of the bottom of the spa. Pull
the outer wall out from the top edge, all around the bottom of the spa, so that it fills evently.
Continue filling the spa until waterf level.
The number of persons required for installation: 1 adult at least.
10 minutes for site preparation and water filling.
Once powered-up, the LED displays the current water temperature automatically.
The temperature units selector changes the temperature units from Celsius de-
grees to Fahrenheit degrees.
Press the temperature adjustment buttons, then the screen will flash. When it is
flashing, you can set the desired temperature. The value will increase or decrease
1 degree at once. The temperature could be set between 30°C to 40°C (86°F to
104°F).
To lock or unlock the control panel, press the Lock button and hold 3 seconds.
Lock the control panel when you are away to prevent other people come to
change your settings..
Press the massage button to activate the bubble massage system, the green
indicator light turns on. It can be turned off by pressing it again.
Note :
- The massage system will stop automatically after 30 minutes of operation. Re-activate the mas-
sage function by pressing the massage button again.
- When filter button is on, pressing bubble button will exchange filter mode into massage mode: filter
indicator light will turn off and massage indicator light turn on. If press the bubble button again, the
massage mode will be changed back to filter mode.
4. USAGE
4.1. Control panel
4.2. Functions
Filtration
Temperature
Decrease Button
Temperature
Increase Button
LED Display
Massage Button
Lock Button
Temperature
units indicator
Temperature
units
selector
Heat Button
