avenli 17283 Series, Manual, Page: 17 / 18

EN
14 15
5.3. Drainage and storage
Drainage
1
Check the stopper on the bottom of the pool and the drain cap.
2
Unscrew the drain cap.
3 Remove the stopper on the bottom of the pool. Completely drain all water from the
spa pool.
Once empty, the pool can be cleaned with soap and water.
Storage
5
Press the bubbling button to blow out the water inside the jet holes. Unplug the
pump, remove the filter cartridge from the inner wall of the pool.
6 Use a towel to wipe off the pool, dry 24 hours.
7
Unscrew the valves to deflate the pool.
8
Fold the pool.
It is recommended that store the SPA in its original package in a warm dry place.
5.4. Repair kit
Little holes or puncture can be repaired with the repair kit included and glue reserved to
pool liner.
1. Find the leak.
2. Thoroughly clean the area surrounding the leak.
3. Cut a piece of repair material in round shape, which should be larger than the dam-
aged area.
4. Apply adhesive to the underneath side of the patch and around the area to be re-
paired.
5. Put the patch on the damaged area and press down firmly. Allow 12 hours for repair
to dry. After patch has dried, apply glue around the edges for a complete seal (dry 4
hours).
1
5
2
6
3
7 8
Here are some useful tips to help you to diagnose and rectify common sources of
trouble.
Problem Cause Solution
Control panel
screen does not
operate
Check power source
Power failure
Reset the RCD plug / Check if the wiring system is adapted to
the power of the pump unit.
Call for service if it does not reset
SPA pump does not
heat properly
Temperature set is too low Set to a higher temperature
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Too low water level Fill water to minimum water level
Heating element defective Call for service
Bubble massage
system does not
work
Pump is overheating Cut off the power and wait until the pump has cooled.
Auto shut-down feature (30min) is
activated
Press the bubble button to reactivate
Malfunction of the pump unit Call for service if it does not reset
Water filtration does
not work
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Inlet and outlet blocked Clean the inlet and outlet
Air inside the pump Fill water to minimum water level
Malfunction of the pump unit Call for service if it does not reset
Pump leakage
Adaptor seal improperly Replace the seal in the right position
Water leakage from pump body Check the pump body, call for service
Spa pool leakage Spa pool is torn or punctured Use provided repair kit (see chapter 5.4)
Water is not clean
Insufficient filtering time Increase the filtering time
Filter Cartridge is dirty Clean or Replace the cartridge (see chapter 5.2)
Pool filled water quality Change the pool water completely
Improper water treatment Refer to the chemical manufacturer’s instructions
CHG FIL
After 150 cumulative hours of filtration operations, an audible alarm will sound and the LCD display will
show the characters CHG, followed by FIL, to remind you to change or clean the filter. You can hold
the filtering button 5 seconds to turn off the buzzing. The filtering system will turn off, you can press the
button to active the filtering system again.
6. TROUBLE SHOOTING
6.1. Troubleshooting