Avdel Genesis nG4, Instruction Manual

Page: 15 / 120

15
ADAPTOR
71213-20101
STEM DEFLECTOR
07340-00342
SEALED NUT
71213-02200
STEM DEFLECTOR: 71213-20100
S t e m D e f l e c t o r
A c c e s s o r i e s
The stem deflector is a very simple alternative to the standard stem collector and allows access in restricted areas. To replace the
stem collector with the stem deflector proceed as follows:
Item numbers in bold refer to the general assembly drawing and parts list on pages 24 and 25.
INNER
OUTER
MAXLOK
®
/EXTENSION 71230-20300
EXTENSION PART NUMBER: 71210-20300
Fitted between the tool and the nose assembly the extension allows
access into deep channels.
•
To fit the extension, remove any nose assembly components.
•
Screw the inner extension to Jaw Spreader Housing 41 .
•
Screw the outer onto Head Assembly 58 .
•
Fit the nose assembly onto the extension.
•
Loosen Locknut 40 using
16mm A Spanner.
•
Unscrew and remove both Jaw
Spreader Housing
41 and
Locknut 40 .
•
Replace Locknut 40 with
‘Sealed’ Nut 71213-02200,
screw ‘Sealed” Nut onto Piston
36 .
•
Jaw Spreader Housing 41
must be tightened onto Piston
36 , finally tightening ‘Sealed’
Nut against it.
•
Remove the Stop Plate
Assembly (page22) by
unscrewing Screws
89 (2 off).
E x t e n s i o n
Preparing the Base Tool for use with Stem Deflector
07340-00342
STEM DEFLECTOR
71213-20101
ADAPTOR
41
40
36
The air line must be disconnected before any servicing or dismantling.
‘Sealed’ Nut 71213-02200 replaces Locknut 40 (to cut-off air supply to Vacuum System) as follows:
Note: If Pintail Deflector is used with Maxlok
®
equipment then Seal Housing 52 will need to be removed and Stop Nut 71233-20200
fitted instead of ‘Sealed’ Nut 71213-02200.
E n g l i s h
•
Fit Stem Deflector (07340-00342) into Adaptor (71213-
20101).
•
Push the assembled Stem Deflector and Adaptor over Bottle
Adaptor
32 and align with the cut-out feature.