Avaya S8730, Maintaining Manual, Page: 31 / 64

1. Turn the SW30 rotary switch located on the top of the board to set the board ID
according to the number of the slot in which the board is installed.
PCI slot number Board ID number
3 0
4 1
5 2
2. Move the SW4 switch located near the top of the board to the OFF-Hook position
by moving the switch toward the bracket of the board.
This switch position sets the hook-switch state so callers hear a busy signal when
the board is not initialized.
3. Set the JP2 jumper to the appropriate position for the system configuration:
• For a system with three boards, move the JP2 jumper on to pins 1 and 2.
• For a system with two boards, move the JP2 jumper on to pins 1 and 2.
• For a system with one board, verify that the JP2 jumper is only on pin 1.
In the following graphic, the setting on the left with pins 1 and 2 jumpered shows
bus termination set to on. The settings on the right show bus termination set to off.
Installing a new port board
Maintaining the Avaya S8730 Server for Modular Messaging June 2009 31