Option
Description
Option
Description
Enable VAD
Use this check box to
enable the Voice Activity
Detection (VAD). When
enabled, the device
suppresses the audio
transmission with
artificial comfort noise
signal to save the
bandwidth.
Enable MWI Tone
Use this check box to
enable playing the MWI
tone when a new MWI
comes.
MCAST page
To access this page, click the
Phone Settings
tab and then click
MCAST
.
This feature allows you to make a broadcast call to people who are in a multicast group. You can
configure a multicast DSS Key on the phone to send an RTP stream to the pre-configured
multicast addresses without involving SIP signaling. You can also configure the phone to receive
an RTP stream from pre-configured multicast listening addresses without involving SIP signaling.
You can specify up to 10 multicast listening addresses
The following table describes the MCAST settings to be configured for the Avaya H229 phone:
Option
Description
Priority
The priority of the active call: 1 is the highest priority
and 10 is the lowest.
Enable Page Priority
The voice call in progress takes precedence over all
incoming paging calls.
Name
Multicast server name.
Host:port
Multicast server’s multicast IP address and port.
Time/Date page
To access this page, click the
Phone settings
tab and then click
Time/Date
.
The following table describes time settings to be configured for the Avaya H229 phone:
Option
Description
Network Time Server Settings
Time Synchronized via SNTP
Use this check box to enable time synchronization
through the SNTP protocol.
Time Synchronized via DHCP
Use this check box to enable time synchronization
through the DHCP protocol.
Primary Time Server
Primary time server address.
Table continues…
Phone Settings tab
October 2019
Installing and Administering the Avaya H229 Phone
39
