Octel 100 Configuration Note
(7036)
Avaya Definity G3 with Vectoring
C o n f i d e n t i a l
P a g e
5
The information contained in this document is provided by AVAYA Inc. to serve as a guide. See the
disclaimer on page 1
Avaya Inc. PROPRIETARY. Use pursuant to Company instructions.
Avaya
C o m m u n i c a t i o n s A p p l i c a t i o n s
G r o u p
Next
Page 2 of 2
STATION
NON-SWITCH DATA
Room:
Headset?
n
Jack:
Speaker?
n
Cable:
Mounting:
d
Floor:
Cord length:
0
Building:
Set Color:
ABBREVIATED DIALING
List1:
List2:
List3:
HOT LINE DESTINATION
Abbreviated Dialing List Number (From above 1, 2 or 3):
Dial Code:
Line Appearance:
call-appr
Enter
5.2
CONFIGURING THE DIGITAL PORT
The following steps are required to program the digital 7434D port to a
VoiceBridge.
Note: There are two sections below describing configuring the digital
ports. The first section, labeled G3V2 and G3V3, is used for G3 V2, and
V3. The second section, labeled G3V4 and G3V5 is used for G3 V4 and
V5. Use the appropriate section for configuring the digital port.
§
Set up the 7434 set as shown in Figure 1, with bridged appearances
beginning on button 11, one for each integrated voice port, up to a
maximum of 24.
§
Configure the Display Buttons as shown in Table 5.
Define the digital port as 7434D terminal using the ADD STATION
command as follows:
Entries in bold italic type indicate
where information must be
entered.