13 (28)
Connecting the multi connector system:
1.
Align the pins of the attachment connector with corresponding
holes of the loader connector. The multi connector will not
connect if the attachment connector is upside down.
2.
Connect and lock the multi connector by turning the lever
towards the loader.
The lever should move easily all the way to its locking position. If the lever does not slide smoothly, check the
alignment and position of the connector and clean the connectors. Also shut down the loader and release the
residual hydraulic pressure.
To disconnect the multi connector system,
1.
Switch off the auxiliary hydraulics of the loader.
2.
While pushing unlock button, turn the lever to disconnect the
connector.
Conventional quick couplings
(alternative couplings for some loader models):
Before connecting or disconnecting the standard quick couplings, the
residual pressure must be released as shown below. The conventional
quick couplings will not connect, if there is pressure in the hydraulic
system.
Make sure that all three quick coupling fittings are properly connected, otherwise the
hydraulic motor of the attachment may get damaged.
To connect and disconnect the standard couplings, move the collar at the end of the female fitting. The hoses
should be connected so that the fitting equipped with a coloured cap is connected to the corresponding fitting
of the loader. Note that the protective caps on the loader and the attachment can be fastened to each other
during operation to reduce the accumulation of dirt. When disconnecting the standard quick couplings a small
amount of oil may drip from the couplings. Wear protective gloves and have some cloth at hand to keep the
equipment clean.
Hydraulic couplings in 200 series loaders:
In a 200-series machine, the hose can be connected by pushing the
fitting in the counterpart. When connecting and disconnecting the 200
series hydraulic quick couplings, note the locking system of the fittings.
There is a small groove in the collar of all female fittings, and a small
ball near the collar. When connecting or disconnecting, the groove and
the ball must be aligned.
The locking prevents the female and male fittings from being
disconnected from each other by accident when the attachment
moves. The collar may also turn accidentally to the locking position,
making it impossible to connect or disconnect the couplings.
Summary of Contents for Collecting Lawn Mower 1200 A21315
Page 2: ...Collecting Lawn Mower 1200 2015 1 ...
Page 28: ......