20 (28)
.
6.6
Emptying the collector box
Monitor the filling of the collector box while operating the mower, and when it is about to fill, stop the mower to
prevent blocking of the collector fan. Drive to the emptying site and open the box door.
The collector box is emptied through
the door on the front side of the box.
Open the box door by pulling from the
lower edge.
To empty the collector, lift the mower and tilt it carefully forward. The clippings are often packed into a
compact package during mowing, and the box is easy to empty in dry conditions. If any clippings are left in the
mower, lower the mower, shut down the loader engine and manually remove any clippings left in the collector
box. Do not drive the loader with the door open or shake the mower rapidly.
Do not reach into the collector box of a raised mower.The mower may move suddenly
due to the floating mechanism. Lower the mower on the ground, follow safe stopping
procedure.
To help keeping the lawn mower clean, empty the collector box as soon as possible after
use.
6.7
Removing a blockage
It is unlikely that the cutting deck gets blocked in normal operation. However, when when mowing wet grass or
driving at too high speed, the side discharge chute may get blocked. If blocking occurs, also check the cutting
deck and clean if necessary.
Always stop the loader by following the safe stopping procedure before going near the
mower. Never reach to the cutting deck if the blades may start rotating or if the mower
can move.
To make sure that the blades will not rotate, disconnect the multiconnector (or hydraulic
quick couplings) before reaching to the mower.
Summary of Contents for Collecting Lawn Mower 1200 A21315
Page 2: ...Collecting Lawn Mower 1200 2015 1 ...
Page 28: ......
