Connection to a Unicable system
AVANIT S2X
43
4.1
Setting the ZF channels and frequencies
Switch on receiver.
Press
on the remote control
Select "Installation" using the
and
keys and press
to
confirm.
Enter the password (on delivery
0000
is preset).
The Installation menu is displayed.
Select the menu item "Antenna Setup" and confirm.
Select the menu item "LNB Freq." and select "Unicable (9750-10600)" there
Select the menu item "IF Channel" and set a ZF channel there
(start with channel "1"; assign one of the ZF channels in ascending order to
every connected receiver).
Select the menu item "Center Freq" and set the frequency belonging to the
ZF channel (see assignment table).
If the set frequency is correct, the level indicators "Signal strength" and
"Signal quality" will indicate the value immediately.
Press the
key
The settings are saved.
You are in the "Installation menu" again
Press the
key twice.
The receiver is in the Normal mode and ready to receive.
Summary of Contents for s2x
Page 13: ...Geräteübersicht AVANIT S2X 13 5 2 3 Tastenbelegung der Fernbedienung ...
Page 46: ...Overview of the Unit 46 AVANIT S2X 5 2 3 Keys of the remote control handset ...
Page 76: ...Vue d ensemble des appareils 76 AVANIT S2X 5 2 3 Boutons de la télécommande ...
Page 96: ...Doc ID 12022301 ...