The Petite-X Revision B 03/2010
SERVICE MANUAL AVALON
La Petite-X
Single-Cup Brewer
60
Servicing Parts
10.2 Shutdown / Storage
If you need to store this brewing equipment for an extended period of time, follow this procedure to avoid
any risk of injury or damage to the equipment.
1. Turn the unit off and unplug from the power outlet;
2. Drain the hot water tank (see instructions);
3. Empty the soluble canisters and the 3 bean canister;
4. Clean all parts of the unit before storing (see cleaning instructions)
5. Disconnect the white double wire from the heating element (see installation diagram)
6. Tie down the water level switch’s arm with a “tie-wrap” to keep the float from pulling down on
the switch during transportation. “
Do not overtighten
”, this may damage the switch; this is
simply to keep the float from bouncing up and down on the switch.
10.2.1 Storing the Brewer Assembly
The brewer assembly is the heart of the equipment and is responsible for the taste of the coffee. It is
therefore
important that you store it properly when it is not in the unit. Always disengage your brewer clutch
by using a pair of pliers and turning the pin located on the back clockwise until the brew chamber lifts
up. This will release the pressure on the screen and seal. Your brewer must be on its back or its left
side while on a table top. Do not sit the brewer on its right side (wheels and yoke) or straight up as
these positions are not sturdy and could cause it to fall.
