AW58EMVAP | AW584EMVSU
User’s Manual
PAGE 12
Technical Support
(650) 384-0000
www.avalan.com
Installation Procedure
Mounting the AW58EMVAP (indoor unit)
___ 1. Apply the mounting bracket to the back of the Access Point using the supplied screws. The side
with the recessed screw holes will be facing you.
___ 2. Mounting Options:
A. Remove the white backing of the supplied adhesive and attach to the back of the quick
disconnect bracket (the lip will be facing away from you).
B. To wall mount use screws (not provided) for the 4 holes on the bracket
___ 3. Locate an area on your store front that the AP can be securely mounted and has visability to
all your dispensers.
Note: Make sure to leave room for your antennas with a 2 inch clearance.
___ 4. Thoroughly clean the prospective mounting surface before removing the red adhesive
backing and applying to the back of the quick disconnect bracket with the flange at the top
of the bracket jutting away from the mount surface.
___ 5. Apply the quick disconnect bracket to the clean mounting area and hold in place for 10-15
seconds to confirm proper adhesion.
___ 6. Connect networking cable from the port in the AP to the female connector on the POE Injector
Note: CAT 6 recommended and up to 100 meters supported
___ 7. Insert the lip from the Quick Disconnect Bracket into the horiztonal opening at the top of AP
___ 8. Connect the male connector on the POE Injector to your existing switch
___ 9. Connect 24 VDC power supply at 120 VAC outlet and POE Injector. The POE Injector will have
a green light present when power is applied.
___ 10. The Access Point will beep once when the power is applied and a second time when the
application is running.
Pairing Radios
___ 1. Power on the Access Point.
___ 2. Hold the Access Point in place while inserting a Subscriber Unit USB Key into the USB port in
side of the Access Point.
___ 3. The AP will acknowledge the USB with a double beep (this can take up to 30 seconds)
___ 4. Remove the USB Key 3 seconds after the double beep then wait for the successful pairing tone
___ 5. Insert the next Subscriber Unit USB key and repeat steps 2-4.
If pairing is unsuccessful there will be a failure tone. Power cycle the Access Point and wait for
the boot tone to proceed. Then re-insert the same USB key and repeat steps 2-4 until you get the
successful pairing tone.