AW58EMVAP | AW584EMVSU
User’s Manual
PAGE 11
Technical Support
(650) 384-0000
www.avalan.com
Installation Procedure
When possible, mount the AW584EMVSU with access to the wiring trough where the dispenser
communication wires are located.
DANGER: Keep a minimum of 3” clearance between the radio (including from the
antenna) and any other equipment.
DANGER: DO NOT USE POWER TOOLS FOR INSTALLATION.
Mounting the AW584EMVSU (in-dispenser units)
___ 1. Power down the dispenser.
___ 2. Open the dispenser bezel and find a mounting location inside the pump with a min. of 3”
clearance from other equipment.
___ 3. Attach the mounting kit plate to the back of the AW584EMVSU.
___ 4. Thoroughly clean the prospective mounting surface, removing any oils, dirt, or residue.
___ 5. After selecting a mounting location, attach the AW58EMVMK metal mounting bracket to the
wall by removing the backing from the adhesive and placing it with the tab oriented
upwards.
___ 6. Hook the opening on the plastic mounting plate over the tab of the metal mounting bracket.
___ 7. Remove the USB key off the Subscriber Unit and write the associate pump on the USB key.
Connecting the Device
___ 1. Connect the device to the four Ethernet ports as shown in the Installation Overview (Figure11.1)
___ 2. Connect the grounding wire to ground and onto the grounding screw.
___ 3. Connect the supplied 24VDC power cable to the dispenser’s power distribution board.
___ 4. Power on the pumps. All Subscriber Units will power up with successful boot tones (a series
of beeps) within approximately 15 seconds.
