Avady POOLeasy pH, Instruction And User'S Manual

Page: 21 / 32

18
STEP 11: Hydraulic circuit
STEP 12: Installation complete
At this stage, the POOLeasy pH or Redox is ready for use without any further adjustments in most cases.
Default pH values
- Setpoint at pH 7.4
- Dosing of acid reagent to bring the pH down
Default Redox values
- Setpoint at 700 mV (corresponding to about 1 mg/l at pH 7.4)
If you would like to obtain a pH of 7.4 and you are dosing with acid, your unit is ready for use without
further preparation. Otherwise, please refer to the following sections to adjust the advanced parameters as
a function of your needs.
Cut Tube J to connect the foot filter B to the pump's left
inlet and the sensor holder D on the pump's right inlet.
Position the foot filter B at the bottom of the trough.
i
: The hydraulic tube is placed in the same way on
the strainer and the pump.
1: Slide the tube through the nut
2: Push the tube down to the bottom of the conical
connector
3: Hand tighten the nut onto the connector
Tube J
A nut
Connector
Valve