Page 7
5.1.1. Cutting the mortises
Using the supplied lock dimensions a mortise
is cut in the door frame that is suitable to
house the lock. An appropriate sized mortise
is then cut for the strike plate and hole to
accept the bolt pin are drilled. The lock pin
hole behind the strike plate needs to be free
from debris and deep enough to allow the
lock pin to fully extend when locked.
5.1.2. Wiring the lock
Wires are run out from the back of the mortise
and following the connection guide on the
locks cover, connected to the lock.
Detailed wiring information can be found in
Section 6 - Wiring.
5.1.3. Fitting the lock and strike plate
The lock is slid back into the mortise, making
sure that the wiring integrity is maintained,
and secured with the supplied mounting
screws. Likewise the strike plate is fitted into
its mortise and secured in place.