AV Stumpfl SC MASTER LITE, User Manual, Page: 60 / 117

52
•
SC NET System
5. By pressing Enter at the SC Master, all connected SD Net
modules are set to configuration mode. This is indicated
by the
DATA LEDs blinking while the SC Master is send-
ing the address into the network. Both remain active for 20
seconds.
6. During this time, press the Setup button on the SC Net
Module to be configured to save the address. You may
have to use a pen to press the setup button. This termi-
nates configuration mode.
Note: You can now check the address set for the module. If
you press the Setup button, the module address is briefly
displayed on the Master unit display. If this does not work for
your units, you may have to update the operating software.
Subadresses of the SC MASTER LITE
The SC MASTER LITE features various interfaces which can
be addressed as follows for SC Net operation:
Display /2 (...for information on the output of
messages refer to the Wings Platinum Online Help)
DMX /DALI /3 and up (up to 64 DMX channels,
output to the REMOTE connector)
Switch outputs /70, /71, /72 and /73 (four AUX relays
and open-collector outputs at the REMOTE connector)
RS232 /90 (RS232-OUT connector)