Page
6
of
56
6.
Insert the camera housing through the ceiling until the retention arms lock into place.
7.
Adjust the pan and tilt to obtain the desired field of view. Then, lock the camera
head in place by tightening at least two of the three set-screws with the
supplied flat-head screwdriver. Do not over torque the screws.
NOTE: Ensure not to press the remote focus motor against the sides of camera
module when adjusting the field of view. Refer to the below image.
8.
Install the dome cover by aligning the captive fastener with the mating threaded
insert on the camera housing. The cover is held in place by magnets.
