Page
10
of
56
NOTE: For installations in harsh environments, it is recommended to use all six
mounting screws supplied with the camera to create the best seal possible
between the camera and the mounting surface and using the supplied gasket.
-or-
b.
Junction Box
1.
Install a 4 in. gang box or square metal junction box (not supplied)
NOTE: ensure openings for cables are accounted for prior to installation.
Figure 4: Install 4S junction box (not supplied)
2.
Insert the supplied gasket inside the gang box.
3.
Insert the camera flush against the gasket inside the 4S gang box; this will be a
tight fit.
NOTE: If you use the side connection of the NPT port, remove the cap covering the
side entrance, otherwise; leave the cap in place. If using the NPT port, always use
Teflon tape around the threads to ensure proper sealing.
4.
Route the cable tree from the camera around the rear of the camera
module and secure all cables. See the Connections section for details on
how to connect the camera.
