Page
11
of
56
5.
Check that the indicator LED’s are illuminated to the desired conditions
(see LED Indicator table).
6.
Adjust the pan and tilt to obtain the desired field of view. Then, lock the camera
head in place by tightening at least two of the three set-screws with the supplied
flat-head screwdriver.
i.
Do not over torque the screws.
Lock camera head after adjusting the field of view
NOTE: Ensure not to press the remote focus motor against the sides of the
camera module when adjusting the field of view.
Remote focus motor
7.
Install the dome cover by aligning the captive fasteners on the camera housing.
If installing inside a 4S junction box, the MCD-4S accessory dome cover plate
(sold separately) is required.
NOTE:
There's no IR function if using MCD-4S
