AUX ALCF-H18/NDR3HA, Service Manual

Page: 67 / 174

R32
High Efficiency DC Inverter LCAC
63
*Press the HEAT button,you can directly enter cooling mode.
* Note: cooling only unit has no heating function.
6.“SWING”button (SWING←→and SWING↑↓)
Press this button to start up/down (left/right) swing function, press itagain,fix louver
position.
*Up/down (left/right) setting is only valid in this mode;it will not affect louver
Position in other modes.
*Up/down (left/right)swing has memory function, it can keep primary setting when turn
off then turn on or switch from other modes to primary mode.
7. “HEALTH” button
* Press this button; you can turn on or off the health function.
8. “SLEEP” button
* Press SLEEP button, the sleeping indicator light of indoor unit flashes on.
* The air-conditioner runs in sleeping mode for 10 hours and quiet sleep mode, recover
back to former mode.
* The unit will turn off automatically if the timing mode is running out of time.
* Note: press the MODE or ON/OFF button, the remote controller clears sleeping mode
away.
9. “iFEEL” button
* Press this button to set “iFEEL”function. The LCD shows the actual room temperature
when the function set and it shows the setting temperature when the function can celled.
* This function is invalid at Fan mode.
10.“DISPLAY” button
* In display mode, press button once, switch off “DISPLAY”, Press “DISPLAY” again,
LCD will show ambient & setting temperature after flashing 5s. It's convenient for users to
check ambient or setting temperature at any time in darkness.
11.“iCLEAN” button
* When remote controller is at the off state, press this button, the unit
runs“iCLEAN”function .
* The purpose of this function is to clean dust on evaporator and dry the inside water of
evaporator and to prevent the evaporator going moldy due to water deposition and boasting
strange smell.
* After setting “iCLEAN” function, press“iCLEAN”button or“ON/OFF”button to quit.
* The clean function will stop working after about 30 minutes running without any