AUX ALCF-H18/NDR3HA, Service Manual

Page: 68 / 174

R32
High Efficiency DC Inverter LCAC
operation.
12.“ELE.H”button(for auxiliary electric heating IDU)
In heating mode,press this button, auxiliary electric heating will work.
13.“Anti-FUNGUS”button
* The purpose of this function is to dry the inside of the evaporator and to prevent the
evaporator from going mouldy due to water deposition and thus dispersing strange smell.
14.“SPOTSWING”button
*Press this button,the horizontal wind direction vanes can swing automatically,when
you have the desired vertical wind direction.
*Press “SPOT SWING”again,the horizontal wind direction vanes will best opped
depend on you.
15.“ECO”button
*In cooling mode, press this button,the unit will run“ECO” economic operation mode
which takes the least power consumption.
*After running for 8h,it will automatically quit.You can press “ECO” button once again to
quit.
*Note:The unit will turn off automatically if the timing mode is running out off time.
16.Two white button: Addressing set
*With the controller off, pressing the two white button simultaneously more than 10
seconds or more to enter address setting.This status displays only temperature and time
parameters,temperature display area shows “Serial number" parameters,the range is 0-99.
Time display area shows "Se tvalue", the range is 0-255.The initial value is 1.
* By pressing “ / ”to set serial and-. Parameter within the serial number
displays from 0 to 99 in circulation.
* By pressing “ECO” and “iCLEAN” to set value and-.Parameters within the
value number displays from 0 to 255 in circulation.After setting the two numbers, press the
MODE button to confirm sending to ODU.
1.2 Wired Controller XK-05/XK-04
XK-05 Features