800-505-8311 [email protected]
Jump Starting Procedure
9
AFTER SALES SUPPORT
USA
USA
600 Peak Battery Amp Jump Starter
1. Turn vehicle ignition and all accessories such as
lights, radio, air conditioner, “OFF”.
2. Make sure all switches on the Power Pack are
turned off (“OFF” position for the Power Pack
Booster Cable Switch - see “A” at left).
3. Securely connect the red (+) clamp to your vehicle
battery’s positive (+) battery terminal (see: “B” at
left).
4. Connect the black (-) clamp to your battery's
negative (-) battery terminal or to a non-moving
metal part of the vehicle (see: “C” at left).
5. Turn Power Pack Booster Cable Switch to “ON”
position
(see: “D” at left).
6. Turn vehicle ignition “ON” and crank the engine
in 3-5 seconds bursts until engine starts.
If vehicle does not start after trying 3 times, check
the battery status and electrical system.
7. After vehicle starts, turn the Power Pack Booster
Cable Switch to “OFF” position. Disconnect the
clamp.
8. If the connections to
the battery’s POSITIVE
and NEGATIVE terminals
are incorrect, the
Reverse Polarity
Indicator will light (red)
and the unit will sound
a beep. Disconnect
clamps and reconnect to
battery with correct polarity.
Make sure unit switch is in the
“OFF” position before connecting
power clamps
Securely connect the red (+) clamp
to your vehicle battery’s positive (+)
battery terminal. Connect the black (-)
clamp to your battery's negative (-)
battery terminal OR to a non-moving
metal part of the vehicle
Turn Switch on Power Pack to
ON position; start vehicle
B
C
A
D
CORRECT PROCEDURE FOR JUMP-STARTING A VEHICLE
If vehicle does not immediately start, turn Power
Pack Booster Cable Switch “OFF” and wait 3
minutes before trying again (failure to wait may
damage Power Pack, vehicle’s starter or electrical
system).
