800-505-8311
Power Port/Battery Status/12V Charging
10
AFTER SALES SUPPORT
USA
USA
600 Peak Battery Amp
Jump Starter
Green Light: Fully Charged
Amber Light: Battery Usable
Red Light: Recharge Necessary
– Do Not Use without recharge
Using 12V DC Power Port of Power Pack
Convenient and simple to use anywhere, the
AUTO XS Power Pack has a 12 Volt plug for all
your 12 Volt accessories.
1. Remove the protective cover.
2. Plug in your 12-volt accessory.
Note: The AUTO XS Power Pack has a 12 amp
automatic overload protection circuit breaker.
Battery Status Monitor
With the AUTO XS Power Pack, you can tell at a
glance how much charge your Power Pack has ready.
1. Before checking the battery status and to receive
an accurate reading, unplug the AC or DC charging
adapter from the unit and wait for few minutes for
correct status reading.
2. Press and hold the Battery Test Button.
3. The Battery Level Indicator LEDs will illuminate to
indicate the amount of charge remaining in the
Power Pack.
12 Volt DC Charging Method
Charging the unit from an external 12 volt DC power
source requires the use of the approved 12 Volt DC
cord. This cord has a male DC connector at each
end (see: “A” at left).
1. Insert the cigarette lighter plug of 12 Volt DC
charge cord into the vehicle’s 12 volt DC accessory
outlet (see: “B” at left).
2. Insert the other end of the plug into the DC input
socket on the front panel of the unit (see: “C” at left).
3. Charge the unit until the green FULL indicator
lights when the Battery Test Button is pressed (with
the DC adapter unplugged from the unit). DO NOT
CHARGE MORE THAN 6 HOURS MAXIMUM
USING THIS METHOD.
4. When charging is complete, remove the charging
cord and store in a safe place.
Note: Some vehicles require that the ignition be
switched to the accessory outlet position in order to
power the accessory outlet.
DO NOT LEAVE THE UNIT UNATTENDED WHEN
CHARGING USING THIS METHOD.
C
B
A
