800-505-8311
Trouble Shooting
12
AFTER SALES SUPPORT
USA
USA
600 Peak Battery Amp Jump Starter
TROUBLE SHOOTING
PROBLEM
POSSIBLE CAUSE
REASON/SOLUTION
Have the battery checked.
Check for poor connection to battery and
frame. Make sure connection points are
clean. Rock clips back and forth for a
better connection.
Clips are not making a good
connection to the battery.
The power pack battery
is not charged.
The vehicle's battery
is defective.
Connections are reversed.
The power pack
won't jump start
my car.
The power pack
won't power my
12V device.
The battery in the
power pack won't
hold a charge.
Check the battery charge status by
pressing the button on the front of the
power pack. See LED Indicators section
of this manual.
Check the battery charge status by
pressing the button on the front of the
power pack. See LED Indicators section
of this manual.
Disconnect the 12V device and press the
reset button located on the back of the
power pack. Try the 12V device again. If
it happens again, replace the 12V device.
Disconnect the power pack and reverse
the clips.
Have the battery checked.
The 12V device is not
turned on.
Turn on the 12V device.
The power pack battery
is not charged.
The 12V device draws more
than 15A or has a short
circuit.
The battery is bad (will
not accept a charge).
