4
Basic Functions
1.
A special combination of buttons presses is used to start the heater with a
remote control key. Firstly press “Lamp” button on the key to switch on the
car’s lighting. Then press “Lock” button two times within 30 seconds, while
lighting is on. Every “Lock” button’s pressing should be confirmed with
direction indicators flashing.
2.
To stop the heater by using a remote control key, twice switch on and then
switch off car’s lighting from the key. Intervals between “Lamp” button
presses should not exceed 20 seconds.
3.
It is possible to disable remotely startups of the heater, programmed in the
CIP. Use a remote control key to send stop command when the heater is idle.
Starting the heater any way or turning the ignition to “on” position enables
CIP timers again.
Additional Functions
By default the module is adjusted to perform only basic functions, such as
start and stop of the heater by using a remote control key. To turn on additional
functions such as flashing with direction indicators in rearview mirrors, etc. enter
the module into Setup mode and activate corresponding setup item (see settings
table 3).
The buttons of the left-hand stalk switch and the brakes pedal are used to
enter Setup mode and to change the settings. It is necessary to stop the engine and
the heater before. Turn the ignition on by holding the engine start button for at
least 2 seconds, then press and hold the brakes pedal. Next press and hold for at
least 5 seconds “Read” button (also can be marked as “OK” button in some cars),
while module’s LED flashes once a second. Both direction indicators in the CIP
confirm entering to the setup mode with 2 flashes*. Release the brakes pedal and
“Read/OK” button finally.
Each setup item in the settings table is a 3-digit code. To enter a digit of a
code, shortly press “RESET” button so much times, as corresponds to a digit. The
LED and the direction indicators symbols in the CIP confirm each button press: the
LED briefly goes off, the left direction indicator flashes one time when the first or
the third digit of code is entered, the right direction indicator - when the second
digit of code is entered. To complete a digit entering, press and release “Read/OK”
button. The CIP confirms it with one flash of both direction indicators
simultaneously. When all three digits entered, the module checks the code for
validity and confirms it with the direction indicators flashing. The both direction
indicators flash twice simultaneously in case of valid code and flash twice
alternately in case of invalid code.
