Page 2
RISK OF ELECTRICAL SHOCK - Digital Nano/Nano+ configured to 115 Vac must be
installed at least 10 feet (3 m) from the pool or spa wall. Digital Nano/Nano+ configured
to 230 Vac must be installed at least 5 feet (1.5m) from the pool or spa wall.
RISK OF ELECTRICAL SHOCK - A disconnect device incorporated into the fixed wiring
must be included in the supply circuit (such as a time clock, relay, or circuit breaker).
RISK OF ELECTRICAL SHOCK - Connect only to a branch circuit protected by a
ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you cannot verify
that the circuit is protected by a GFCI.
RISK OF ELECTRICAL SHOCK - Digital Nano/Nano+ must be connected only to a
supply circuit that is protected by a ground-fault circuit-interrupter (GFCI). The GFCI
must be tested on a routine basis. To test, push the GFCI test button. Power should be
interrupted. Push the reset button. Power should be restored. If the GFCI fails to operate
in this manner, it is defective.
RISK OF ELECTRICAL SHOCK - If the ground-fault circuit-interrupter (GFCI) interrupts
power to the equipment without the test button being pushed, a ground current is flowing
with a possibility of an electrical shock. Do not use equipment. Disconnect the
equipment and have the problem corrected by a qualified service representative before
using.
CHEMICAL HAZARD - To avoid damaging splashes, always add acid to water, never
water to acid. Wear safety glasses and use other appropriate personal protection
equipment.
CHEMICAL HAZARD - Always follow the instructions on the manufacturer's label
whenever handling or using chemicals.
CHEMICAL HAZARD
– Heavy pool (or spa) usage and higher temperatures may require
a higher chlorine output in order to maintain proper free available chlorine residuals.
WATER CHEMISTRY SAFETY - Improper water chemistry can present a serious health
hazard. The proper residual chlorine level and water chemistry must be maintained. The
addition of certain pool maintenance chemicals can reduce the effectiveness of chlorine.
Maintain Pool / Spa water per standards detailed later in this manual.
COMBUSTIBLE HAZARD
– The AutoPilot
®
Digital Nano/Nano+ is equipped with an
electronic flow switch that automatically turns the unit off in the event of a “low water
flow” situation. Do not tamper in any way with this safety feature.
PERSONAL SAFETY HAZARD
– To reduce the risk of injury, do not permit children to
operate this device.
RISK OF CHILD DROWNING OR INJURY - Children must be closely supervised at all
times around pool or spa equipment.
CAUTION
: Failure to heed the following may result in equipment damage.
The AutoPilot
®
Digital Nano/Nano+ must be installed and operated as specified. Failure
to do so will void the equipment warranty.
To permit proper air circulation, the Digital Nano/Nano+ must be mounted at least 1-foot
(30 cm) above ground level or any other cooling obstruction.
Special measures are required in the event of freezing conditions. Your Digital
Nano/Nano+ may be damaged if measures are not taken in advance of freezing
conditions. Equipment damage due to freezing conditions is NOT covered under the
equipment warranty.
Do not use a pool cleaner or vacuum head with wheels, as wheels can leave track
marks on newly-plastered pools. Do not allow Granular salt to pile up in one location,
without brushing, as staining may occur.
