4.1 Attaching Cables
When attaching standard video input and output cables, refer to the sheet labeled
“AutoPatch Modula Connector Guide” found inside the back cover of this
binder. The sheet shows where to attach each cable on the rear of each enclosure.
(For multi-enclosure systems, an enclosure number sticker is on the rear of each
enclosure.) Follow the sheet exactly; the system was programmed at the factory
to operate
only
as indicated on the sheet.
Make sure the standard video cable is connected to the correct BNC connector on
the correct enclosure. Standard video and HV sync boards look similar to
SD-SDI digital, HD-SDI digital, and wideband boards, but the “AutoPatch
Modula Connector Guide” identifies them.
To connect standard or HV sync video inputs and outputs,
fasten the cable
connector onto the input and output BNC connectors (see Figure 12).
4-2
Modula Boards & Specifications
Standard Video
24
IN
22
23
21
4
1
2
3
8
5
6
7
12
9
10
11
16
13
14
15
20
IN
17
18
19
IN
IN
IN
IN
Figure 12: Fasten the cable onto the input or output BNC connector
Standard
Video
Summary of Contents for Modula 34-27
Page 1: ......
