3.1 Attaching Cables
When attaching S-Video input and output cables, refer to the sheet labeled
“AutoPatch Modula Connector Guide” found inside the back cover of this
binder. The sheet shows where to attach each cable on the rear of each enclosure.
(For multi-enclosure systems, an enclosure number sticker is on the rear of each
enclosure.) Follow the sheet exactly; the system was programmed at the factory
to operate
only
as indicated on the sheet.
Modula S-Video boards are equipped with locking S-Video connectors. When
used in conjunction with AutoPatch S-Video cables, the connectors and the
cables lock into place. Cables with standard S-Video connectors may also be
used, but will not lock.
To connect S-Video inputs and outputs,
fasten the cables onto the input and
output S-Video connectors (see Figure 8).
To fasten a locking S-Video connector,
either pull back on the housing of the
connector (see Figure 9) while pushing the connector in, or hold the connector at
a slight angle to the right while pushing in.
To remove a locking S-Video connector
, pull back on the housing of the
connector.
Caution:
To avoid damaging a locking S-Video connector or board, be sure to
pull on the connector housing instead of the cable.
3-2
Modula Boards & Specifications
S-Video
8
5
6
7
OUT
Figure 8: Fasten the cable onto the connector
S-Video
Figure 9: Pull back the housing to fasten the connector
Housing
Summary of Contents for Modula 34-27
Page 1: ......
