5.1 Attaching Cables
When attaching wideband video input and output cables, refer to the sheet
labeled “AutoPatch Modula Connector Guide” found inside the back cover of
this binder. The sheet shows where to attach each cable on the rear of each
enclosure. (For multi-enclosure systems, an enclosure number sticker is on the
rear of each enclosure.) Follow the sheet exactly; the system was programmed at
the factory to operate
only
as indicated on the sheet.
Make sure the wideband video cable is connected to the correct BNC connector
on the correct enclosure. Wideband video boards look similar to SD-SDI digital,
HD-SDI digital, standard video, and HV sync boards, but the “AutoPatch
Modula Connector Guide” identifies them.
To connect wideband video inputs and outputs,
fasten the cables onto the
input and output BNC connectors (see Figure 14).
5-2
Modula Boards & Specifications
Wideband Video
24
IN
22
23
21
4
1
2
3
8
5
6
7
12
9
10
11
16
13
14
15
20
IN
17
18
19
IN
IN
IN
IN
Figure 14: Fasten the cable onto the input or output BNC connector
Wideband
Video
Summary of Contents for Modula 34-27
Page 1: ......
