Jun/22/2009
RST1000 OP REV.A
12
Slow Flash
Armed
2 flashes... pause
Zone 2 / Trigger on Trunk
Fast Flash
Passive Arming
3 flashes... pause
Zone 3 / Trigger on Door Switch
On (Solid)
Valet Mode
4 flashes... pause
Zone 4 / Trigger on Shock Sensor
Pause On
Password Lock-Out
5 flashes... pause
Zone 5 / Trigger on Ignition Switch
C. CHIRP INDICATORS:
D. PARKING LIGHT:
Chirp
Function
Parking light
Function
1 chirp
Arm
1 flash
Arm
2 chirps
Disarm
2 flashes
Disarm
3 chirps
Ajar Warning
3 flashes
Disarm / Triggered
4 chirps
Disarm / Triggered
12 flashes
Car Locator
6 chirps
Car Locator
Constant On
Under Remote Start
E. ACTIVE ARMING – LOCK & ARM:
1. Press the
button on the transmitter.
2. The siren will chirp once and parking light will flash once indicating that the system is now armed. The
vehicle door will lock upon arming when interfaced with the security system.
AJAR WARNING: If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.
SILENT ARMING:
Spin up the
switch to the page
1
and then press the “Silent Arm” button
or press the
transmitter
and
buttons at the same time to arm your security system, No chirp sound will be heard,
arm confirmation will be through the vehicles parking lights only.
SENSOR BY-PASS:
Bypass The Zone 4: Spin up the
switch to the page
2
and then
press the button
1
or press the
button on the transmitter two
times within 3 seconds. This will arm the security system and
by-pass the zone 4-shock sensor.
The system will chirp one additional time to confirm the sensor bypass mode was activated. The sensor
bypass feature is programmed to activate for one arming cycle only. The security system will return to
normal operation during the next arming cycle.
HIDDEN ALARM FUNCTION (Silent Alarm): Spin up the switch to the page 1
and then press the “Hidden Alarm” button or press the
button first; within 3
seconds press the
button to activate the hidden alarm function. The security
system will arm and with “Hidden Alarm Function” The siren / horn will be silenced
even if the unit is triggered in the armed status. Notification will only be through the
hand held two-way remote.
F. PASSIVE ARMING (Programming Required)
Active arming / disarming is controlling your security system via the remote transmitter. This security
system is equipped with an optional Passive Arming feature which allows the security system to arm 30
seconds after the last door is closed. Operation is as follows.
1. Turn the ignition to the “OFF” position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any
door / hood / trunk, the security system LED will stop flashing. It will begin flashing again once all of the
vehicle entrances are closed.
3. After 30-second timer has elapsed, the security system will automatically “ARM”. The siren will chirp [1]
time and the parking lights will flash [1] time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING:
The vehicle doors will automatically lock after passive arming cycle has been completed.
PASSIVE ARMING BY-PASS: While the system disarmed, Press the
button twice, the security will
respond with [1] chirp and LED will turn “ON”. The security system will remain in this temporary state for as
