Autonics TK Series, User Manual

Page: 38 / 124

5 Preparation and Startup
38 © Copyright Reserved Autonics Co., Ltd.
5.2 Basic controls
5.2.1 Parameter setting sequence
Parameters of each group are connected each other. Therefore, follow the below parameter
order.
Parameter 3 Group [
PAR3
]
→
Parameter 4 Group [
PAR4
]
→
Parameter 5 Group [
PAR5
]
→
Parameter 2 Group [
PAR2
] → Parameter 1 Group [
PAR1
] → SV Setting [
SV
]
Changing Parameter 3 Group's parameters can sometimes reset other associated parameters.
Always make sure to check if such parameters have been affected.
5.2.2 Set value (SV) setting
①
Press any key among , , in RUN mode to enter SV
setting mode. Last digit (10
0
digit) on SV display part flashes.
②
Press the key to move digit.
(10
0
→
10
1
→
10
2
→
10
3
→
10
0
)
③
Press the , keys to raise or lower the set value.
④
Press the key to save the set value. If there is no additional
key operations in 3 sec., the changed SV is automatically saved.