Owner Installation Instructions
NeoSlider
TM
- Sliding Gate Opener NES-24V3
11
Fig 8.1
Fig 8.2
8. Setting Limits
8.5 Automatic limit adjustment and load profile
After a brief pause, the controller will automatically close and open the gate several times. This adjusts the speed at which
the limits are approached and helps to learn the normal load profile of the gate. When the setup is complete, the MAIN
SCREEN will be displayed with the gate shown to be OPEN. The Gate can now be used.
NOTE:
Do not press transmitter during limit adjustment process.
8.6 Pedestrian access position
After completing the above procedure, the Pedestrian access position is automatically set to a position which is five (5)
seconds from the fully closed position of the gate. The position can be manually set by following the SETTING PEDESTRIAN
POSITION procedure (See Section 12).
8.7 Errors during setting of travel limit
During the above procedure, many error checks are preformed. If an error is detected, a message will be displayed
indicating the error.
8.8 Recalculate Force Margins
a. Reprofiling is a simplified way of re-learning the travel characteristic of a previously setup Limit Switch travel installation.
Re-profiling can be used when the travel characteristics of the gate change due to mechanical adjustments etc.
b. To initiate a re-profile simply locate “MENU 10.2 Reprofile Travel”
WARNING: The gate(s) will automatically close and open. Ensure that no persons or objects are in the
gates path.
c. Press SET then follow the prompts. The gate will start to move and re-calculate force margins. The gate can move
between the open and close limit positions up to two (2) times (depending on the position of the gate and the power
up condition).
d. A single beep will be heard once the process is complete and setup complete message will be displayed
