Owner Installation Instructions
GDO-11v2 Ero®
29
57
fi g
Final Setup
Step 24 - Setting the Pet Mode position
The default Pet Mode height can be changed as follows:
Drive and stop the door at the desired Pet Mode
open position by pressing OPERATE button on
the console or the transmitter button coded for
O/S/C operation.
Press and hold the OPEN button
(Fig 57)
for six
(6) seconds until the OPEN and CLOSE LED’s are
lit to record the new pet position.
When activated, Pet Mode drives the door to the preset
position from the close position. Pet Mode’s active status
is indicated by both the OPEN and CLOSE LIMIT LED’s
being illuminated. If a Pet Mode button is pressed while
the door is moving, the door will stop. If a Pet Mode
button is pressed when the door is in the Pet position,
then the door will close.
Step 25 - Installing the Wall Mounted
Transmitter (Optional)
Remove the faceplate from the transmitter.
Affi x the baseplate in a convenient wall location
(Fig 58)
that is out of reach of children at a height
of at least 1.5 metres from the fl oor and where
the door is visible
Replace the faceplate.
To code the transmitter, see Steps 15.2 through
15.3 on page 19.
Step 26 - Reset all Factory Defaults
Turn power to opener off.
Press and hold the SET Button
(Fig 56).
Turn power on while holding the SET button.
Continue to hold until all the LED’s are off.
NOTE:
This will not erase transmitter codes stored in
the memory.
a.
b.
a.
b.
c.
d.
a.
b.
c.
59
fi g
58
fi g
