Automatic Products Showcase 748, Operating Manual

Page: 6 / 107

APi 748 V1.1 406 1.3 P/N 77500001
Back
Section 1: Installation
INTRODUCTION
This section contains instructions for unpacking
the APi 748 Showcase® Merchandiser and
installing it on location. It is important for ease of
service, reliability, and safety that you install the
machine properly.
UNPACKING INSTRUCTIONS
The APi 748 is shipped in one carton with all
major assemblies in place, ready for installation.
The shipping carton should be opened carefully to
prevent the 748 from being scratched or
damaged. Inspect the exterior and interior of the
cabinet for evidence of damage. If evidence of
damage exists, notify the delivering carrier at once
to examine the 748 regardless of the external
condition of the carton. Under U.S. regulations,
damage claims must be collected from the
consignee. Do not return shipping-damaged
merchandise until after your claim has been
established. Once your claim has been
established, damaged merchandise may be
returned to an authorized distributor for repair.
The invoice for repair charges may then be
collected from the carrier. Do not destroy packing
material or boxes until the carrier’s agent has
examined them.
SETUP INSTRUCTIONS
1. Place the unit in a well-ventilated location with
a minimum of SIX INCHES between the 748
and a back wall.
2. Remove all tape and packing material from the
cabinet.
3. The 748 must be leveled. Perform level
adjustment by using the following illustration:
Place level in the (A) position and adjust the
bottom leg levelers. Perform same on position
(B) then (C).
Figure 1-1.
Level Adjustment
4. Ensure that circuit breakers are firmly in place
and the fluorescent lamps are secure in their
sockets.
5. Ensure that the Main Power Switch is in the
OFF position.
6. Plug the line cord into a dedicated, properly
grounded receptacle capable of delivering the
required power.
7. Install a supported coin changer (see chart
below).
a) Check coin chute alignment
b) Check coin return lever operation
c) Adjust if necessary
8. Install a bill acceptor if desired. Note: If you use
a MDB coin mech, you must use a MDB bill
acceptor or card reader. (See chart below).
9. If using FIFO mode, insert the selection
number labels in the corresponding Delivery
Doors. From top to bottom, the door
numbering convention is: 01, 02, 03, 04, 11,
12, 13, 14, 21, 22, 23. You only need to label
those shelves you intend to operate in the
FIFO mode.
10.Check and ensure that all electrical
connections are seated properly, especially at
the circuit boards.
CAUTION! Pushing or
sliding the 748 (by hand) on
the floor can result in
considerable damage to the
machine and/or personal
injury. Always use
appropriate material
handling equipment and
adequate protective
padding to protect the 748.
DOOR
Place level in position A, and adjust the bottom
leg levelers, and repeat in positions B & C
B C
A
CAUTION – DO NOT
DEFEAT THE SAFETY
GROUND
CAUTION! If the 748 is not
leveled correctly the
refrigerator evaporator may
ice up, causing the unit to
shut down.