Electronic Dartboard 3
Setup / Mounting Instructions
Choose a location to hang the dartboard where there is about 10 feet of open space in front of the
board. The “toe-line” should be 7’ 9 1/4” from the face of the dartboard
Locate a wall stud and place a mark 75.78” from the floor. This mark is for the top screw hole. For
the bottom screws, you will measure 62.5 inches from the floor. Using a pencil, make a reference
mark very lightly on the wall. (do not drill a hole in the “reference mark” that you have made) You
will then need to place a mark 6.31 inches to the left of that reference mark. That will be the
location for the left side bottom screw. You will then make another mark 6.31 inches to t he right of
the original reference mark you made. That will be the location for the right side screw.
Mount the dartboard on the wall by lining up the holes on the back with the screws. It may be
necessary to adjust the screws until the board fits snugly against the wall.
Center of Bullseye should be
5’ 8” from the floor when finshed
X
X
Wall Stud
Bottom
Screw
62.75”
Top Screw
73.75”
Floor
7’ 9
¼
”
Toe Line
5’ 8” from Floor
to Center of
Bullseye
Dartboard
