Warning: Under heavy loads the
PSU case will become hot.
ALWAYS ensure the ventilation
slots have a clear flow of air. Do
not place combustible materials
against / adjacent to the PSU.
3.2 Mains Connection
For your safety it is IMPORTANT that
you follow these connections
instructions each time your Leisure
Vehicle is connected to a mains supply.
•
Ensure suitability of the Mains
Supply.
Your Leisure Vehicle should only be
connected to an approved supply that
meets the requirements of BS7671. In
most cases the site warden will hold
information regarding suitability of
supply. If using a generator you also
need to comply with the requirements
/ instructions supplied with the
generator.
•
Switch the PSU internal
Charger unit OFF.
Locate the red ‘Charger’ power switch
on the PSU and ensure the switch is
in the OFF (0) position before
connection to the mains supply.
•
Connect the Hook-up Lead.
Firstly connect the supplied hook-up
lead (orange cable with blue
connectors) to the Leisure Vehicle and
then connect to the mains supply.
•
Check Residual Current
Device operation.
Locate the RCD within the PSU and
ensure the RCD is switched on (lever
in up position). Press the TEST button
and confirm that the RCD is turned
off (lever in down position). Switch
the RCD back to the on position
(lever in up position). If the test
button failed to operate the RCD see
section 3.4.
•
Check correct Polarity.
Locate the ‘Reverse Polarity’ indicator
on the PSU2007 and ensure that the
indicator is NOT illuminated. If the
indicator is illuminated see section 3.4.
•
Check Miniature Circuit
Breakers.
Locate the MCB’s within the PSU
(adjacent to the RCD) and ensure
they are all in the ON (up) position. If
any MCB’s fail to latch in the on
position see section 3.4.
•
Turn the PSU ON.
Locate the red power switch on the
PSU and turn to the ON (I) position.
The switch will illuminate when
turned on.
•
Check operation of
equipment.
It is now safe to check the operation
of the 12v and 240v equipment.
8. ELECTRICITY: SERVICES
