In the event of a gas fault (eg gas
cylinder empty), the operating
display (C) flashes yellow.
Switching the refrigerator off
Turn energy selector (A) to “OFF”
position.The refrigerator is now
switched off.
Important: If you are leaving your
vehicle for an extended length of
time (eg greater than two weeks)
the energy selector (A) should be
turned to the “OFF” position.
Failure to do this could result in a
fully discharged leisure battery
which could cause long term
damage to the vehicle.
Thetford N145 Refrigerator
Controls
The N145 Refrigerator is equipped
with Smart Energy Selection (SES).
When you start up the refrigerator
you should usually select the ‘auto’
mode.The SES energy system will
then automatically select the best of
the three available energy sources.
The system will apply the following
priority:
• Mains voltage (230V)
• Direct current (12V)
• Liquid gas
If none of the above energy sources
are available, the LED of the main
switch will turn from green to red
and flash every second.
Switching on the refrigerator
The first time you start the SES
system the system will automatically
start up in the auto mode in the
middle temperature setting.The
memory of the SES system saves
every change made to the setting.
Consequently, the SES system will
start up on each subsequent
occasion in the last selected setting.
A. Main switch
B. Mode selection switch
C.Temperature selection
switch
D. Display LED
1. Open the valve of the gas bottle.
2. Open the taps of the gas supply.
3. Press main switch (A).The LED
along side the main switch will turn
green.
4. Use the mode selection switch to
select the ‘Auto’ function or one of
the power supplied that you want.
The LEDs will show the option you
have selected.
5. Set the desired refrigerating
temperature by means of the
temperature selection switch ©.The
LED will show the temperature you
have selected.
A Use the main switch to switch
7. GAS: APPLIANCES
