Depending on the room temperature the heater will
automatically select the output of the heater required.
Once the room temperature has been reached, the heating
will switch off (regardless of the water temperature).
If the boiler is full of water then it will be heated automatically
at the same time.The water temperature is however
dependent on the seat output of the heater and will switch
off when the room reaches the desired temperature.
In this condition the yellow monitor lamp (g) will only light up
if the water temperature is below 5 °C.
Switching Off
(Gas Operation)
Switch the heating system off at the rotary switch (f).
If the appliance is not to be used for long periods, close the
isolation valve in the gas supply line and turn off the gas
cylinder.
Red Indicator ‘Failure’
In event of a fault the red monitor lamp (h) will light up.
Reset the system by switching the heater.
230V Electrical Operation (Hot water only)
When the rocker switch is in the ‘on’ position (j) the switch
will illuminate to show that the water heater is operating.
The water temperature is automatically regulated to 60°C.
Truma Ultraheat
When your vehicle is fitted with Ultraheat, you will find a
separate wall switch with 500W, 1000W and 2000W settings.
Switching on
• Check that you have a mains supply, and that the fuse spur
is switched on.
• Turn control ring (b) to required power setting.
• Set rotary control knob (c) to desired room temperature.
The Ultraheat can either be used as an independent heater
or can be used in conjunction with the gas system to give a
maximum 5.2kW output.
For night time use it is recommended that the Ultraheat
system is switched to the 500W setting.
25
7. Gas: Appliances
230V Electrical Operation
(Hotwater Only)
j Rocker switch ‘on’
k Rocker switch ‘off’
Truma Ultraheat
A
- Slide switch: OFF
B
- Rotary switch: ON
Poer settings:
500-1000 - 2000W
C
- Rotary control knob for room
temperature (illuminated by green
indicator lamp “operation’
E
E
B
B
A
B
C
Final 2006 AT Handbook 1/12/05 12:06 pm Page 25
