Auto-Sleepers Topaz, Handbook

Page: 81 / 108

9-31
FITTED EQUIPMENT
SLEEPING ARRANGEMENTS
TOPAZ
Single bed
Nearside - Slide front passenger seat to
rearmost position, raise the armrest and then
rotate through 180º to face rearward.
Release the catch on side of the rear seat
and pull forward to touch the front seat. Use
the infill cushion and adjust the front seat
height, if necessary, to form a flat bed.
Offside - Slide the driver’s seat rearward and
recline the seat back as far forward as
possible. Push the swivel release lever at the
front of the seat sideways and rotate the seat
slightly to the left. (Note that it may be
necessary to lower the handbrake first, see
page 4-2). By use of the fore and aft adjuster
on the seat base and by adjusting the
position of the armrests, manoeuvre the seat
so that it is rotated through 180º, to face the
rear of the vehicle. (Note that this operation is
easier with driver’s door open). Return the
seat back to the upright position.
Pull the sofa seat base forward sufficiently to
allow the backrest to drop vertically in behind
it. Use the infill cushion and adjust the front
seat height, if necessary, to form a flat bed.
Double bed
Make up the nearside bed, and arrange the
driver’s seat as above. Release the catch on
the front of the offside sofa and pull forward
until it meets the nearside bed. Arrange the
sofa backrest cushion and long infill cushion
to fill the remaining gap. Fit the infill cushion,
with folding legs, between the front seats.