10
11
BATTERY TEST (cont.)
3
If the reading is below 7.2 Volts you will get the following:
Surface charge removed if
detected.
Wait for test results.
Bar at the bottom of the screen
will show the tests progress.
The SB-300 serial number and test number are displayed to help
reference the test to the print out.
SUMMARY SCREEN
TESTING BATTERY
PLEASE WAIT...
S#23456 T# 1
Confirm that the inputs are
correct. Press 'Y' if they are
correct. The test will start.
Press 'N' to re-enter battery
type, temp, and rating.
>IS THIS A 6V
BATTERY?
'N' OR 'Y'
REMOVING SURFACE
CHARGE...
S#22010 T#32
STARTING STANDRD
TEMP: 70F
RATED CCA 600
'N' OR 'Y'
Press the (+Up) or (-Down) key
to increment or decrement to the
rated CCA of the battery.
>ENTER RATED CCA
600 USE +/-
12.68V
'Y' TO CONTINUE
After the Digital Pulse Load Test is completed results similar
to one of the following sample screens will appear.
Battery passes
testing. Return to
service.
Charge battery and place into
service.
Battery did not have a sufficient
charge for a Digital Pulse Load
Test. Charge and retest battery.
Battery passes testing and is near
end of life. Battery is ok for mild
climate. May not start vehicle in
hot or cold conditions.
Battery did not have
sufficient remaining
capacity to pass tests.
Battery should be replaced
immediately.
BATTERY TEST (cont.)
T#1 12V BATT.
GOOD BATTERY!
12.84V CHRG 100%
'Y' TO CONTINUE
T#1 12V BATT.
BAD BATTERY!
12.68V CHRG 100%
'Y' TO CONTINUE
T#1 12V BATT.
GOOD NEEDS CHRG.
12.38V CHRG 60%
'Y' TO CONTINUE
T#1 12V BATT.
CHARGE & TEST
12.08V CHRG 20%
'Y' TO CONTINUE
T#1 12V BATT.
NEAR END OF LIFE
12.68V CHRG 100%
'Y' TO CONTINUE
