8
13
HOOK UP
Press the On/Off button: Connect the clamps as
instructed on the LCD.
Enter the approximate battery
temperature in degrees Fahrenheit or Celsius then press (Y Enter).
Note:
Go to the setup to change temp scale to Celsius. The temperature
request only appears once for each battery tested. If the clamps are
disconnected you will be prompted again to begin a new battery test.
Note!
Take special care when connecting to battery side terminals.
If necessary use a side post adapter to prevent thread damage. When
testing dual post batteries always connect load clamps to the post to
which the system is attached.
CONNECTION ERRORS
If the clamps are reversed the Reversed Connection
screen will flash.
If one or both of the clamps are not in complete contact
CHECK CONNECTIONS! will flash
Make sure the Infrared Printer is
properly set up.
After a test is made with the
SB-300 make sure the results
are displayed on the LCD.
Point the SB-300 in the direction
of the Infrared Printer (within 15
ft.)
Press the <Print> key and the
test results will be printed.
Depending upon the test made
the printer will sometimes yield
more information than the LCD.
PRINTING TEST RESULTS
Point the SB-300 in the direction of the PR-12 printer
with the printer’s IR receiver pointed in the direction of the
SB-300. Press (Print). You should be within 15 ft of the printer. Wait for
the screen to clear before moving the SB-300. It takes a moment to send
all the test data. The SB-300 also operates the AC-14 printer installed
in Auto Meter’s XTC-160 tester/charger or BVA-2100 heavy-duty tester/
analyzer, or Auto Meter's PR-16 Printer when used with a XTC-160 and
IR-1 Printer Interface.
AUTO METER
SB-300
TESTER/ANALYZER
'Y' FOR MENU
>ENTER BATTERY
TEMP: 70F
USE +/-
'Y' TO CONTINUE
1
