8
1
1
HOOK UP
Press the On/Off button: Connect the clamps as instructed on the LCD.
Enter the approximate battery
temperature in degrees Fahrenheit then press (Y Enter).
Note:
Go to the setup to change temp scale to centigrade. The temperature
request only appears once for each battery tested. If the clamps are dis-
connected you will be prompted again to begin a new battery test.
Note!
Take special care when connecting to battery side terminals. If
necessary use a side post adapter to prevent thread damage. When
testing dual post batteries always check the post to which the system is
attached. If a load test is made from a post connection and the alterna-
tor is mounted to side terminals a battery load test can be completed, but
a continuity problem may still be in the side terminals when testing the
alternator.
CONNECTION ERRORS
If the clamps are reversed the Reversed Connection LED
will light up.
If one or both of the clamps are not in complete contact
(both the copper and silver jaw) CHECK CONNECTIONS!
will flash.
Make sure the Infrared Printer is
properly set up.
After a test is made with the
BVA-200s make sure the results
are displayed on the LCD.
Point the BVA-200s in the
direction of the Infrared Printer
(within 40 ft.)
Press the <Print> key and the
test results will be printed.
Depending upon the test made
the printer will sometimes yield
more information than the LCD.
Wait until the printer stops print-
ing before you press the BVA-
200s print key again.
PRINTING TEST RESULTS
Multiple Test Printing:
Pressing the print button
repeatedly (up to six times)
will automatically print the test
in review and the previous
tests.
Point the BVA-200s in the direction of the AC-15 printer (in or out of the
case) with the printer’s IR receiver pointed in the direction of the BVA-
200s. Press (Print). You should be within 40 ft. of the printer. Wait for
the screen to clear before moving the BVA-200s. It takes a moment to
send all the test data. The BVA-200s also operates the AC-14 printer
installed in Auto Meter’s XTC-150 tester/charger or BVA-200s0 heavy
duty tester/analyzer.
AUTO METER
BVA 200s
SYSTEM AMALYZER
READY TO CONNECT
>ENTER BATTERY
TEMP 70F
USE +/-.
‘Y’ TO CONTINUE
