©2005-2015
AutoMate Scientific, Inc.
All rights reserved.
ValveLink8.2
®
User’s Manual
The ValveLink8.2 is intended for research use only.
Table of Contents
AutoMate Scientific
®
R E A D Y F O R R E S E A R C H.
TM
Introduction ........................................................................................3
Hardware Overview
ValveLink8.2 Laboratory Applications
Accessories
ThermoClamp
™
-1 Temperature Control System
Pressure Regulated Perfusion System
Perfusion Pencil
®
Multi-Barrel Manifold Tip
System Set-up Diagrams
............................................................8
Standard PTFE Perfusion System (without pressure)
Pinch Valve, Pressurized and Luer-Lock Perfusion Systems
Installation Tips
Bubbles and Degassing
Perfusion Cheat Sheet
PTFE Micro-manifold Use
Pinch Valve Tubing
Valve Care
Perfusion Pencil Flow Rates
Perfusion Pencil Multi-barrel Manifold
Perfusion Pressure Kit
Josef Kewekordes II, Heath Lukatch
Dave Blau
ValveLink8.2 - Part #01-18
For indoor use only from 5° to 40°C.
Do not get wet or subject to visible condensation.
Clean with a mild soap solution with a damp cloth only.
This equipment must be earth grounded. Use any of the screws on the side
or bottom of the case. See page 23.
Do not unplug valves while on!
Do not attempt to repeatedly cycle valves on and off in under
one millisecond.
If this equipment is used in a manner not specified by the manufacturer,
the protection provided by the equipment may be impaired.
Supply voltage:
ValveLink8.2 controller = 12V AC up to 3.3 amps @ 50-60Hz
External power supplies:
USA & Japan = 110V AC up to 0.36 amps @ 60Hz
European = 230V AC up to 0.17 amps @ 50Hz
!
