23
USERS GUIDE
www.auroramm.com
Necessary parts
• 2 mounting screws
• 2 plugs
• Mounting bracket (included in the box)
How to install
1.
Drill two holes in the wall as indicated on the drawing.
Horizontal distance: 177 mm ± 0.15
2.
At the bottom of the base unit, place the bracket on the 4 holes and screw in the 4 screws until fastened.
3.
Insert a plug in each hole (if needed, depends on the wall type), and drive in 2 screws. Please leave at
least a 0.15mm space to place the bracket between the screw header and wall. Ensure that the head of
the screw is not bigger than the bracket’s mounting hole.
Note: Mounting screws and plugs are not included in the TeamStream box. The type of screws depends on
the type of wall (stone, wood, plasterboard, ...) you are mounting the base unit to. Make sure the head of
the screw is not larger than the hole in the bracket.
4.
Place the TS-100 on the wall, so that the holes on the bracket match the 2 unfixed screws on the wall. The
bracket should not be touching the wall too closely. Hoop the bracket on the screw and slide the base unit
downwards until it’s affixed in the 2 screw on the wall.
5.
Set the bracket in place with the 2 unfixed screws.
Antenna placement rules
The antennas should be oriented vertically (perpendicular to the ceiling and parallel to the walls).
The antennas should be installed far enough (at least 50cm/1.6ft) from metallic surfaces to avoid unwanted
reflections and far enough (at least 1m/3.3ft) from other radio equipment that operates in the same
frequency range, e.g. other Wi-Fi access points, cordless telephones and microwave ovens. It is also best