Rev. 02/11
AMMF16R-1
9
ADJUSTING MIST DENSITY
CAUTION:
Do not over tighten and/or loosen the water flow control valve.
The misting function of this fan is adjusted by turning the flow control valve on the fan pole assembly
clockwise to decrease mist density or counter-clockwise to increase mist density. It may take a minute for
misting to start. It is normal for air to come out of the nozzles before water and the mist comes out.
To optimize the cooling effectiveness of the system, you can:
Operate the unit with a DRY or WET mist, based on your needs.
To increase the mist density, turn the mist control valve counter-clockwise (fig.10).
To decrease the mist density, turn the mist control valve clockwise (fig.11).
2. Operating Tips
For dry climates, increasing the water flow will provide maximum cooling results. In humid climates, a
reduced water flow is recommended.
CUSTOMER RESPONSIBILITIES
Read and follow the maintenance schedule and the maintenance procedures listed in this section.
WARNING:
ALLWAYS UNPLUG THE POWER CORD BEFORE MOVING OR
SERVICING THE MISTING FAN.
WARNING:
DO NOT IMMERSE THE MISTING MIST FAN IN WATER!
REPLACING FILTERS
WARNING:
ANY SERVICING OF THIS UNIT, EXCEPT FOR GENERAL
MAINTENANCE DESCRIBED IN THIS SECTION, SHOULD BE PERFORMED BY AN
AUTHORIZED SERVICE REPRESENTATIVE.
CAUTION:
The filters have been designed to provide optimal system
performance by catching any debris that may enter the supply lines throughout use.
Semi annual replacement of both the air and water filters ensures the life of your
system.
Remove the filter cover and locate the air and water filters (fig.1).
The filters are connected to the system via “Push-In” connectors for ease of service
Maintenance
