Rev. 02/11
AMMF16R-1
6
A Phillips head screwdriver is needed for assembly.
1. Ensure that the power cord is disconnected from the power outlet.
2. Align fan pole assembly to the power base assembly hole as illustrated. Gently push the hose and
power cable aside and press the mist fan pole until the screw hole is aligned to the base (fig. 1).
CAUTION
- Make sure you do not kink the hose in this process.
3. Fasten the fan pole assembly to the power base assembly with the two screws (fig. 1).
4. Fasten the fan pole to the power base assembly with the fan pole screw (fig. 2).
5. Loosen the pole lock knob and pull the inner pole out, then tighten the pole lock (fig. 3).
6. Loosen the locking knob on the fan head assembly and attach the fan head assembly to the pole then
tighten screw knob to secure the fan head assembly (fig. 4).
7. Disassemble the rear fan guard nut and the misting fan blade nut from the misting fan head assembly
(fig.5).
8. Align the rear fan guard holes to the three pins on the motor housing, and fasten the rear fan guard to
the fan head assembly with the rear fan guard nut (figure 6).
9. Mount the fan blade to the fan motor shaft (fig.7). Make sure the fan blade gap aligns with the pin clip
on the motor shaft and screw on the blade nut (fig.8).
10. Align the front and rear guard and secure all the hinges around the outer rims of the fan guard (figures
9 & 10).
11. Fasten the front and rear fan guards with the supplied screw (fig. 11).
12. Connect all three nozzle housings by gently sliding the nozzle housing into the holder on the front fan
guard (fig.12).
13.Connect the air tube and water tube to the connectors on the misting fan pole assembly by pushing the
tubes all the way into the corresponding connectors (fig.13). (Note, small diameter tube = Water and
large diameter tube = Air)
General Assembly Instructions
