Rev. C 04/08
01030
4
4. Connect the two wires, and close the electrical
housing with housing lid in
bag 2
(B-2 and B3).
5. Align and slidebase cover and fasten to back
and front of mist control / fan pole assembly with
two screws from
bag 3
(C-1).
C-1
6. Install mist control unit by using fasteners from
bag
6.
Pull the water and air tube through the opening on
the side of the fan pole assembly until they are inserted
securely in the “Push-In” connector (C-2).
C-2
FAN POLE ASSEMBLY TO MOTOR
ASSEMBLY
1. Attach the motor to the Center Pole and fasten
securely (D-1) with all fasteners from
bag 4
. Use an
adjustable wrench to tighten the fasteners.
FAN GUARD AND BLADE ASSEMBLY
1. Locate the small screw and nut at the bottom of the
rear guard and position it so it is pointing to the ground.
Mount the rear guard to the fan motor with screw from
bag
5
(E-1).
2. Mount the fan blade to the fan motor (E-2). Make
sure the fan blade set screw is on the flat section of the
fan motor shaft. Complete the fan assembly by
removing the small screw and nut, and mounting the
Electrical housing lid
Base cover
Mist control unit
Air hose
Water hose
