Rev. C 04/08
01030
6
F-3
OPERATING INSTRUCTIONS
Read this owner’s manual before operating this
product
1. To operate the misting fan, plug the power cord into
a 120 VAC, 60Hz outlet.
CAUTION:
FAN AND/OR MISTING SYSTEM
MAY START UP WHEN THE UNIT IS INITIALLY
PLUGGED TO THE POWER OUTLET.
2. Fan Operation (ON-OFF, Speed control)
Pull Action
Speed
First High
Second Medium
Third Low
Fourth “OFF”
3.
Fan Operation (Oscillation Control)
To turn on the oscillation function, press down the
oscillation switch, to stop the function simply pull-up
the oscillation switch. The oscillation angle is
approximately 50
°
(G-1)
G-1
4. Misting Operation
IMPORTANT:
This product is designed to
operate with DRINKING WATER ONLY. Fan
and/or misting system may start up when the unit
is initially plugged to the power outlet.
BEFORE STARTING
• Remove fill cap on power base assembly and fill with
DRINKING WATER through the basket filter until tank
is filled to approximately 1” below the bottom of the
basket filter.
• Add ½ teaspoon of unscented chlorine bleach to the
water tank (approximately 5 drops per gallon of drinking
water).
• Replace cap and hand tighten.
•
The misting function of this product is turned on by
simply rotating the switch on the fan pole assembly,
clockwise. It might take around 2-4 minutes for a new
misting fan to start misting, and it is normal for air to
come before water.
ADJUSTING MIST DENSITY
To optimize the cooling effectiveness of the system,
you can:
•
Operate the unit with a DRY or WET mist,
based on your needs.
•
To increase the mist density, turn the mist
control valve counterclockwise.
•
To decrease the mist density, turn the mist
control valve clockwise.
When the misting fan is turned “OFF”, the air-pump
continues to work for approximately 2 to 4 minutes.
This allows the air-pump to clear the remaining water
from the nozzle hoses to prevent accumulation of
deposits and reduce the risk of clogging.
5. Operating Tips
Use DRINKING WATER only in the system. For dry
climates, increasing the water flow will provide
maximum cooling results. In humid climates, a reduced
water flow is recommended.
MAINTENANCE
WARNING:
ALLWAYS UNPLUG THE POWER
CORD BEFORE MOVING OR SERVICING
WARNING:
DO NOT IMMERSE THE MISTING
FAN IN WATER!
CUSTOMER RESPONSIBILITIES
Read and follow the maintenance schedule and the
maintenance procedures listed in this section.
EMPTYING WATER TANK
•
Place misting fan on surface where water can be
drained to.
•
Remove drain plug by turning counterclockwise.
•
Allow tank to drain completely.
•
Replace drain plug and hand tighten turning
clockwise.
CLEANING BASKET FILTER
•
Remove fill cap and remove basket filter.
•
Rinse debris from filter with running water.
•
Replace basket filter and fill cap.
